r/SmartThings • u/Intelligent-Bath-137 • 3d ago
Aqara FP300 paired with Aqara Hub M1, but not syncing to SmartThings
Hi everyone,
I’m having trouble getting a second Aqara FP300 sensor to show up in SmartThings.
My setup:
Samsung SmartThings ecosystem, with my Samsung S95F acting as a SmartThings hub
Multiple Aqara hubs, including an Aqara M2 and an Aqara M1
Both Aqara hubs are visible in SmartThings
The issue:
My FP300 connected to the Aqara M2 in the living room works perfectly in SmartThings.
However, I recently added another FP300 to an Aqara M1 hub. The sensor works in the Aqara ecosystem, but it doesn’t appear in SmartThings, even though the M1 hub itself is visible there.
I can’t remember whether I added the M2 to SmartThings before or after pairing the FP300 with it. So I’m wondering whether the order in which the hub and sensor are added makes a difference.
My questions:
Should FP300 sensors paired with an Aqara hub automatically appear in SmartThings?
Is there a difference between the Aqara M1 and M2 when exposing connected devices to SmartThings?
Could the pairing or integration order explain why the FP300 connected to the M2 works, while the one connected to the M1 doesn’t?
Would removing and reconnecting the M1 integration help, or could that cause issues with my existing setup?
I’d prefer to keep using Zigbee rather than Matter if possible.
Has anyone experienced something similar or managed to get this exact setup working?
Thanks in advance!
1
1
u/Intelligent-Bath-137 2d ago
It works, I didn’t realize that the name of the device wasn’t synchronized
2
u/aroedl 2d ago
Connect your Aqara FP300 directly to your SmartThings hub with this driver:
https://community.smartthings.com/t/st-edge-aqara-fp300-zigbee/306507